SETUP TIPS from Michael van der Haas
I am running some of the hop up options:
- alloy prop shaft
- tamiya heat sink
- hi-torque servo saver
- yeah racing dampers
- bearing set
- 25 tooth
I am using the standard motor mount rather than the alloy one, and a much more 6000 battery with a futaba 3003 servo.
So yeah, a servo saver on the lowest spec servo probably wasn’t nessecary.
Now for the dampers setup: (same all round)
- Yeah racing red dot springs (the softest in the yeah racing set)
- 700 damper oil
- 2 hole pistons
While this spring and oil combo seemed spot on for outdoors, I think slightly stiffer springs will be best for indoors.
Good luck all!